Handleiding Eureka Silver Canyon 6 Tent

Handleiding

Contents of Carry bag

Tent body

Tent fly

Pole bag:4 steel straight poles (leg poles)

2 long bright orange aluminum poles (roof poles)

Stake bag: 13 stakes

E!LUMINATE SYSTEM: 2 silver panels

Eureka! Media Center (gear hammock with clear panel)

Gear Hammock

1. Spread the tent body out, floor side down. Locate the yellow webbing

stake out loop, as this marks the right front corner of the tent. Also locate

the black plastic elbow hub & grey fabric roof pole sleeves which cross in the

top center of the tent body.

2. Assemble the two bright orange aluminum roof poles

3. Starting at the corner with the yellow webbing stake out loop, follow the

sewn seam past the plastic hub and insert one of the poles into the grey

fabric pole sleeve. Continue sliding the pole through the sleeve until it

reaches the black plastic hub at the opposite corner. Insert the pole end into

the hub opening which has internal ribs. (NOTE: the other hub opening is

smooth & is used for the larger diameter leg poles.) Repeat process with the

second pole & sleeve. Correctly threaded, the poles will make a large X

shape, crossing in the middle of the tent.

4. Assemble the four leg poles & place one at each corner of the tent.

5. Starting at the yellow webbing stake out loop, insert the open end of the

leg pole into the smooth opening of the black plastic hub. Raising the pole &

hub, reach down and insert the tip of the pole into the outer-most grommet

(metal ring) on yellow webbing stake out loop. Moving to another corner,

repeat process with second pole, then a third, & lastly the fourth. Your tent

will now be standing.

6. Walk around the tent and connect all of the black plastic clips to their

respective poles.

7. Secure the tent to the ground using the stakes provided. Start at the

yellow webbing stake out loop, next proceed to the diagonally opposite

corner. While firmly pulling on the black webbing stake out loop, hammer in

the stake. Repeat process with the other two corners. Now stake the

middle stakeout loops along the sides and back (Silver Canyon 6).

Attaching the Fly Sheet

1. Unfold the fly & drape it over the tent matching the yellow webbing on

the fly with the yellow webbing on the tent body. Align and center the fly

on the tent body so the fly’s seams follow the tent body’s poles.

2. Locate the bright orange triangular wing at the upper corners of the

fly. Reaching under the wing, wrap the hook/loop closure around the

underlying pole below the black plastic hub to secure the fly to the pole.

Farther down the pole & fly is another the hook/loop closure located

underneath the reflective webbing guyout point. Also wrap this

hook/loop closure around the pole to secure the fly to the pole. At the

bottom edge of the fly, clip together the side-release buckle securing the

fly to the stakeout loop.

3. Repeat wrapping the hook/loop closures around all of the three

remaining leg poles and clipping together the side-release buckles to

secure the fly to the tent’s pole structure.

4. Walk around the tent & equally tension all four corner webbings by

pulling the webbing through the buckle to tension the fly.

5. Securing the Front Vestibule: At the front of the tent, locate the four

black webbing stake-out loops. Starting with the outermost loops, pull

equal tension on each loop & secure each loop with a stake. During

inclement weather, stake inner two black webbing loops attached to the

vestibule’s center panel for extra security.

6. Silver Canyon 6 only: Securing the Rear Vestibule: Locate the two

black webbing stake-out loops. Pull tension on a loop & secure with a

stake. Durning extreme weather, stake the remaining loop for extra

security.

7. Vectored Side Pullouts: This tent features fly-to-tent body pullouts.

At the mid-point on each side of the tent, reach under the fly’s edge,

slide the black “dog bone” toggle through the “O-Ring” located on the

tent body. Attach a provided guyout cord to the small webbing loop.

Secure guyout cord with a stake. Repeat process on other side(s) of

tent. The Vectored Side Pullouts enhance ventilation, increase the

tent’s interior living space, and strengthen the overall tent during

inclement weather.

8. Guyouts: The bright orange triangular wings also contain pockets

which store the pre-attached guyout cords. Remove the cord from the

pocket & extend it to full length. Secure the guyout cord to the ground

with a stake. In high winds, an additional guyout cord can be attached

to the reflective black webbing loop halfway up the leg pole. Get in the

habit of always using the guyouts even in good weather.

8. The tent body will now be erect, properly tensioned, and secured to

the ground.

Eureka! Set-Up Instructions

Silver Canyon 4 (#2601286)

Silver Canyon 6 (#2601291)

REV 082714

Setting up the Tent Body

E!Luminate System:

Increases the brightness of floor-level lighting provided by LED lanterns

inside the tent. Two removable triangular silver-reflective E!Luminate

panels install in the ceiling with O-rings & toggles The panels reflect a

lantern’s light downwards to the floor, increasing the brightness of

floor-level light up to 3 times. A reinforced webbing hang loop with D-ring

securely holds LED lanterns at the tent’s peak. An elegant, yet simple &

effective solution to brighten the nighttime camping experience.

NOTE: Only for use with battery powered LED lanterns.

EUREKA! Media Center:

Watch video on tablets & other small electronic devices from the comfort

of your sleeping bag. The clear center panel of the Media Center is

touchscreen friendly. The Media Center attaches with hooks to pre-in-

stalled O-rings located in each corner of the tent. Also secure the center

of the Media Center with the cord & hook to support heavier items.

High/Low Viewing: For viewing while laying down use the lower sets of

O-rings. For seated-level viewing, suspend the Media Center from the

top corner O-rings and the middle O-rings. Always remember to support

the middle of the Media Center, using the central cord’s 3-hole slider to

adjust the tension as needed.

Gear Hammock:

The gear hammock attaches with hooks to pre-installed O-rings located

in each corner of the tent. Secure the center of the hammock with the

cord & hook to support heavier items.

E! Power Port:

The zippered E! Power Port allows you to bring an electrical power cord

inside the tent.

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Eureka Silver Canyon 6 Tent. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Eureka. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Eureka Silver Canyon 6 Tent in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Eureka Tenten
Meer handleidingen voor Tenten

Veelgestelde vragen over Eureka Silver Canyon 6 Tent

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Eureka Mountain Pass 3XTE Tent

Handleiding

Eureka Forte Sq 2 Tent

Handleiding

Eureka Totokon 4 Tent

Handleiding

Eureka High Camp Tent

Handleiding

Eureka Tetragon HD 8 Tent

Handleiding

Eureka Dominion Tent

Handleiding

Eureka Jade Canyon 6 Tent

Handleiding

Eureka Totokon 2 Tent

Gerelateerde categorieën