Handleiding iTronics IT-01 Aromaverstuiver

Handleiding

-8- -9-

ENEN

3H

4H

1H 2H

In the event of the unit being knocked over or tipped during use, please follow

the steps below to avoid malfunction.

Unplug the unit and remove cover.

Pour any remaining water out of the water tank.

Shake the unit gently to drain any water inside the mechanism, and then

allow drying for at least 24 hours.

Accidental Leakage

3H

4H

1H 2 H

3

H

4

H

1H

2

H

3

H

4

H

1

H

2H

Troubleshooting

Experiencing issues with your device? Please check below troubleshooting

tips before contacting us if you wonder whether damage occurred.

SYMPTOM

Unit is not

powering on

No mist or

abnormal mist

Water leakage

from product

POSSIBLE CAUSE

Is there any water in the water

tank?

Is there enough water in the

water tank?

Is the power cord connected

properly?

Not enough water?

Too much water ?

Dirt on the ultrasonic plate?

Cover and inner cover are not

installed properly?

Dirt on the air suction port

at the base?

Cover and inner cover are not

installed properly?

Has the inner cover shifted?

Low temperature or high

humidity?

SOLUTION

Add water to tank.

When there is no water or a little amount

of water in the water tank, the power

supply will automatically and immediately

turn off after pressing the MIST button.

Disconnect the adapter, check cables

and re-connect carefully.

Add water to tank.

When the water reaches above the max,

the mist will be abnormal.

Clean the water tank. (Please refer to

the Maintenance Section)

Fix the cover and inner cover because

the mist cannot reach to the FOG

NOZZLE without right installation.

If there is dirt on the air suction port,

the airflow will be restricted and then

mist cannot be blown out.

Fix the cover and inner cover.

The produced mist cannot reach to FOG

NOZZLE and will cause water droplets if

the cover and inner cover shifted.

Under these conditions, the mist may

condense quickly into water droplets.

Electrical and electronic components must not be disposed of

with the domestic waste. Once the product reaches the end of

its service life, dispose of it and its components separately in

accordance with the local valid regulations for disposal.

Disposal

Wipe with a soft cloth. Avoid Ultrasonic Vibration plate area, Which can

be gently cleaned with a cotton bud.

Pour out any remaining water from the “DRAIN SIDE” of the tank.

Unplug power cord from the base of unit. the

Put 1 tablespoon of citric acid in the water tank, add just under 120 ml of

warm water.

Leave for 5 minutes, and then drain solution from the “DRAIN SIDE” of the tank.

Unplug the unit from mains power supply and remove cover.

After using 5-6 times, or 2 3 days, please clean the product as follows.-

Maintenance

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je iTronics IT-01 Aromaverstuiver. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met iTronics. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van iTronics IT-01 Aromaverstuiver in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor iTronics Aromaverstuivers
Meer handleidingen voor Aromaverstuivers

Beoordeling

Gerelateerde producten

Handleiding

Serene House Starlight Aromaverstuiver

Handleiding

Beurer LA 35 Aromaverstuiver

Handleiding

Concept DF2010 Aromaverstuiver

Handleiding

Beper 70.405 Aromaverstuiver

Handleiding

Quigg BS2W300-W Aromaverstuiver

Handleiding

Anjou AJ-AD012 Aromaverstuiver

Handleiding

Hoffen AD-9536-B Aromaverstuiver

Handleiding

Quigg BS2W300-D Aromaverstuiver

Gerelateerde categorieën