Handleiding Snapper RD21V40 Grasmaaier

Handleiding

SERVICE AND MAINTENANCE

Safe Handling of Gasoline

1. Extinguish all cigarettes, cigars, pipes, and other sources of

ignition.

2. Use only approved gasoline containers.

3. Never remove the gas cap or add fuel with the engine running.

Allow the engine to cool before refueling.

4. Never fuel the machine indoors.

5. Never store the machine or fuel container where there is an

open flame, spark, or pilot light such as near a water heater or

other appliance.

6. Never fill containers inside a vehicle or on a truck bed with a

plastic bed liner. Always place containers on the ground away

from your vehicle before filling.

7. Remove gas-powered equipment from the truck or trailer and

refuel it on the ground. If this is not possible, then refuel such

equipment on a trailer with a portable container, rather than

from a gasoline dispenser nozzle.

8. Keep nozzle in contact with the rim of the fuel tank or container

opening at all times until fueling is complete. Do not use a

nozzle lock-open device.

9. If fuel is spilled on clothing, change clothing immediately.

10. Never over-fill the fuel tank. Replace gas cap and tighten

securely.

11. Use extra care in handling gasoline and other fuels. They are

flammable and vapors are explosive.

12. If fuel is spilled, do not attempt to start the engine but move the

machine away from the area of spillage and avoid creating any

source of ignition until fuel vapors have dissipated.

13. Replace all fuel tank caps and fuel container caps securely.

Service & Maintenance

1. Never run the unit in an enclosed area where carbon

monoxide fumes may collect.

2. Keep nuts and bolts, especially blade attachment bolts, tight

and keep equipment in good condition.

3. Never tamper with safety devices. Check their proper

operation regularly and make necessary repairs if they are not

functioning properly.

4. Keep unit free of grass, leaves, or other debris build-up. Clean

up oil or fuel spillage. and remove any fuel-soaked debris.

Allow machine to cool before storage.

5. If you strike an object, stop and inspect the machine. Repair,

if necessary, before restarting.

6. Never make adjustments or repairs with the engine running.

7. Check grass catcher components and the discharge guard

frequently and replace with manufacturer’s recommended

parts, when necessary.

8. Mower blades are sharp. Wrap the blade or wear gloves, and

use extra caution when servicing them.

9. Check brake operation frequently. Adjust and service as

required.

10. Maintain or replace safety and instructions labels, as

necessary.

11. Do not remove the fuel filter when the engine is hot as spilled

gasoline may ignite. Do not spread fuel line clamps further

than necessary. Ensure clamps grip hoses firmly over the filter

after installation.

12. Do not use gasoline containing METHANOL, gasohol

containing more than 10% ETHANOL, gasoline additives, or

white gas because engine/fuel system damage could result.

13. If the fuel tank must be drained, it should be drained outdoors.

14. Replace faulty silencers/mufflers.

15. Use only factory authorized replacement parts when making

repairs.

16. Always comply with factory specifications on all settings and

adjustments.

17. Only authorized service locations should be utilized for major

service and repair requirements.

18. Never attempt to make major repairs on this unit unless you

have been properly trained. Improper service procedures can

result in hazardous operation, equipment damage and voiding

of manufacturer’s warranty.

19. On multiple blade mowers, take care as rotating one blade can

cause other blades to rotate.

20. Do not change engine governor settings or over-speed the

engine. Operating the engine at excessive speed can

increase the hazard of personal injury.

21. Disengage drive attachments, stop the engine, remove the

key, and disconnect the spark plug wire(s) before: clearing

attachment blockages and chutes, performing service work,

striking an object, or if the unit vibrates abnormally. After

striking an object, inspect the machine for damage and make

repairs before restarting and operating the equipment.

22. Never place hands near the moving parts, such as a hydro

pump cooling fan, when the tractor is running. (Hydro pump

cooling fans are typically located on top of the transaxle).

23. Units with hydraulic pumps, hoses, or motors: WARNING:

Hydraulic fluid escaping under pressure may have sufficient

force to penetrate skin and cause serious injury. If foreign fluid

is injected into the skin it must be surgically removed within a

few hours by a doctor familiar with this form of injury or

gangrene may result. Keep body and hands away from pin

holes or nozzles that eject hydraulic fluid under high pressure.

Use paper or cardboard, and not hands, to search for leaks.

Make sure all hydraulic fluid connections are tight and all

hydraulic hoses and lines are in good condition before

applying pressure to the system. If leaks occur, have the unit

serviced immediately by your authorized dealer.

24. WARNING: Stored energy device. Improper release of

springs can result in serious personal injury. Springs should

be removed by an authorized technician.

25. Models equipped with an engine radiator: WARNING: Stored

energy device. To prevent serious bodily injury from hot

coolant or steam blow-out, never attempt to remove the

radiator cap while the engine is running. Stop the engine and

wait until it is cool. Even then, use extreme care when

removing the cap.

8

Safety Rules & Information

Not for

Reproduction

Beoordeling

Meer over deze handleiding

We begrijpen dat het prettig is om een papieren handleiding te hebben voor je Snapper RD21V40 Grasmaaier. Je kunt de handleiding bij ons altijd downloaden en daarna zelf printen. Indien je graag een originele handleiding wilt hebben, raden we je aan contact op te nemen met Snapper. Zij kunnen wellicht nog voorzien in een originele handleiding. Zoek je de handleiding van Snapper RD21V40 Grasmaaier in een andere taal? Kies op de homepage je taal naar keuze en zoek daarna op het modelnummer om te zien of we deze beschikbaar hebben.

Specificaties

Alle handleidingen voor Snapper Grasmaaiers
Meer handleidingen voor Grasmaaiers

Veelgestelde vragen over Snapper RD21V40 Grasmaaier

Ons supportteam zoekt dagelijks naar nuttige productinformatie en antwoorden op veelgestelde vragen. Als er onverhoopt toch een onjuistheid tussen onze veelgestelde vragen staat, laat het ons dan weten via het contactformulier.

Gerelateerde producten

Handleiding

Cobra RM46SPH Grasmaaier

Handleiding

EGO LMX5300SP Grasmaaier

Handleiding

McCulloch M51-140WR Grasmaaier

Handleiding

Parkside IAN 420301 Grasmaaier

Handleiding

Oleo-Mac Cheyenne 92 Grasmaaier

Handleiding

Stihl RMA 253.3 T Grasmaaier

Handleiding

Husqvarna LB 442 Klippo Grasmaaier

Handleiding

Greencut GLM590X Grasmaaier

Gerelateerde categorieën